Adept EX SmartContoller - Manual (Page 56)

Chapter 4: Maintenance
10. Push the front cover into the body, taking care to align all of the plug-type connectors.
Verify that the wires do not get crimped as you reinstall the cover.
11. Replace the two screws on the back of the body.
12. Reinstall the Front Panel in its mounting.
13. Reconnect the cable between the Front Panel and the controller.
High Power On/Off
Lamp Body
Back side of front cover
Wires between LED and
body of Front Panel.
Be careful when separating
front cover from body to avoid
damaging the wires.
Figure 4-1. Lamp Body Contact Alignment
Adept SmartController EX User’s Guide, Rev. B
Page 56 of 96