Appendix b – Zilog Z51F0811 User Manual
Page 93
UM024002-0512
The Z8051 OCD In-System Programmer
Z8051 On-Chip Debugger and In-System Programmer
User Manual
85
Appendix B. OCD Driver Installation on
Windows XP Systems
The driver programs for the Z8051 On-Chip Debugger are copied during the software and
documentation installation. On Windows XP systems, ensure that the target side of the
OCD will remain unconnected while you install these drivers. It is important that you
observe the following procedure; do not skip ahead until the OCD drivers are installed.
1. Connect the OCD hardware to the USB port of your PC by connecting the A-Male end
of one of the two USB A (male)-to-Mini-B cables with the host PC’s USB port, and
connect the Mini-B end to the OCD device.
2. After the PC detects the new hardware, it will display the
Found New Hardware Wiz-
ard
dialog box, shown in Figure 95. Select
Install from a list or specific location
(Advanced)
; then click
Next
.
Figure 95. The Found New Hardware Wizard Welcome Screen