Zilog Z51F0811 - Manual (Page 23)

UM024002-0512 The Z8051 On-Chip Debugger
Z8051 On-Chip Debugger and In-System Programmer
User Manual
15
6. The debugger will automatically search for map and symbol files associated with the
hex file and load these files to memory.
7. After the map/symbol files are loaded into memory, the debugger resets the target
MCU and moves the MCU’s program counter to 0000h .
8. Save the current debugging environment to the hard drive of your development PC
and exit the Debugger by selecting Exit from the File menu.
Emulation Menu
The Emulation menu, shown in Figure 13, lists the controls for starting or stopping an
emulation routine. Use the Emulation menu to control the flow of code execution for
debugging purposes.
The remainder of this section describes the features of the Emulation menu.
Reset & Go
This menu selection starts an emulation from the 0000h address upon a reset of the target
MCU, and functions in a manner similar to a Power-On Reset. Emulation continues until a
breakpoint occurs or the user stops the emulation process. The Reset & Go menu is dis-
abled (greyed out) in the Emulation menu during emulation.
Figure 13. The OCD’s Emulation Menu