Zilog Z51F0811 - Manual (Page 12)

UM024002-0512 The Z8051 On-Chip Debugger
Z8051 On-Chip Debugger and In-System Programmer
User Manual
4
If you have already installed the Z8051 software and documentation from the CD-ROM
following the procedure on the paper insert in your kit (FL0138 or FL0139), skip this sec-
tion and proceed to the Z8051 OCD Driver Installation section, below.
Observe the following procedure to install the Z8051 On-Chip Debugger software and
documentation on your computer.
1. Ensure that the OCD interface hardware is not connected to your PC.
2. Insert the Z8051 Software and Documentation CD into your computer’s CD-ROM
drive. The setup program launches automatically. If the setup program does not launch
automatically, open Windows Explorer, browse to your CD-ROM drive, and double-
click the file labeled
Z8051_.exe .
In this filename, refers to the version number of the OCD Software
and Documentation release. For example, this version number may be 1.0 .
3. Follow the on-screen instructions to complete the OCD software installation.
Z8051 OCD Driver Installation
The driver programs for the Z8051 On-Chip Debugger are copied during the software and
documentation installation. In the following procedure for PCs running Windows 7 32-
and 64-bit operating systems, ensure that the target side of the OCD will remain uncon-
nected while you install these drivers.
If you are running Windows Vista, see Appendix A on page 82 to install your device driv-
ers. If you are running Windows XP, see Appendix B on page 85.
1. Connect the OCD hardware to the USB port of your PC by connecting the A (male)
end of one of the two USB A (male)-to-Mini-B cables with the host PC’s USB port.
Connect the Mini-B end to the OCD device.
2. After the PC detects the new hardware, it will display the Installing device driver soft-
ware dialog shown in Figure 2.
Note:
Note:
Note: