Xtramus NuWIN-RM V1.4 - Manual (Page 14)

14
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS ®
Please follow the steps down below to start NuWIN-RM and NuServer properly.
Starting NuServer
When starting NuWIN-RM
, a “Connect To
NuServer ” window will pop up and ask how you
are going to connect to NuServer.
 Local Host: Choose this option when you’re
running NuWIN-RM from NuStreams-2000i
IPC module or a PC that’s connected to
NuStreams-2000i/600i via an RJ45 cable.

Remote Host: Choose this option when
you’re running NuWIN-RM from other PC
located on the network. Choose the IP
address which is assigned from
NuStreams-2000i/600i from the scroll-down
menu, or choose demo to enter NuWIN-RM
’s
Demo Mode.
 Connect/Cancel: Click the Connect/Cancel
button to connect to NuStreams-2000i/600i or
cancel starting NuWIN-RM.
A “NuServer-NIC Information” window will pop
up. Please select the NIC (Network Interface
Card) which is connected to NuStreams -2000i/
600i’s from the Network Interface Information
table, and click OK
. If you’re using
NuStreams- 2000i’s IPC module, please choose
“Realtek RTL8139 Family Fast Ethernet”.
NuServer will connect to the daughter boards,
and NuWIN-RM will start as well.