Vectronics VEC-884 - Manual (Page 13)

VEC-884 Owner's Manual
Introduction Error! Main Document Only.-5
Front Panel Layout
AGC button: Press to enable the automatic gain control;
press again to turn it off.
Program button: Press to program memory filters, to talk, or to
activate CW spotting tone.
Memory button: Selects either normal or memory filters mode.
Filters switch: Selects one of ten normal or ten memory
filters.
PWR LED: Indicates normal (red) or memory (green) mode.
Input Level LED: Indicates input signal level (red too high, off too
low, green is OK).
Tunable Filters left knob: Adjusts tunable filters and manual notch.
Manual Notch button: Press to enable the manual notch; press again
to turn it off.
Tunable Filters right knob: Adjusts tunable filters and manual notch.
Auto Notch button:
Press to enable the automatic notch; press
again to turn it off.
Noise Reduction knob: Controls the level of noise attenuation.
Noise Reduction button: Press to enable the noise reduction; press
again to turn it off.
Volume control: Controls the output volume level to speaker
and headphones jacks.
Speaker button: Press to enable the speaker jack; press again
to turn it off.
DSP button: Press to turn on digital processing of input
signal; press again to bypass processing.
Power button: Press to turn the power on; press again to
turn the power off.
For an in-depth description of the front panel controls, refer to Chapter 3,
Operation.