Vectronics VEC-1862 - Manual

VEC-1862 Instruction Manual Six-meter Yagi Antenna
1
VEC-1862 Instruction Manual
INTRODUCTION
Thank you for purchasing the VEC-1862 three-element six-meter Yagi. The VEC-1862
is a light-weight directional antenna especially designed for installation with readily-
available TV-type masts, mounts, and hardware. The driven element employs a "no-tune"
hairpin impedance matching system, and all elements are cut to exact length at the
factory. No adjustment should be needed for coverage of the 50-MHz SSB band (see
page 8 for FM-segment tuning instructions). Because of its compact size, light weight,
and unique construction, the VEC-1862 is also a excellent choice for six-meter portable
or "rover" operation. In weak-signal DX applications, two VEC-1862s may be stacked
for increased capture area and 3-dB additional gain. The VEC-1862 has been computer
modeled on both ELNEC

and YA

to confirm design integrity, and has been
thoroughly field tested in northern climates for winter survivability.
TYPICAL SPECIFICATIONS
Boom length 6'
Turning Radius 5' 8"
Longest Element 117-1/2"
Weight 2.5 lbs.
Feed Impedance 50
Ω
Resonant Frequency 50.3 MHz
1.5:1 VSWR Bandwidth 1.7 MHz
Forward Gain 6.0 dBd (8.2 dBi)
Front-to-Rear Ratio >18 dB measured
Maximum Power 150 Watts
SAFETY PRECAUTIONS
Before assembling, please read the following safety notice:
This antenna is an electrical conductor--do not handle or mount near power lines, service
entrances, or other dangerous power sources. Mount out of the reach of adults, children,
and animals. Antenna elements develop lethal voltages and may cause severe RF burns
during transmitter operation. For lightning protection, always ground your supporting
mast to two or more outdoor ground rods. Disconnect the feedline from your radio when
not in use. Do not expose pacemakers or other bio-medical equipment to strong RF
radiation. To avoid personal injury or damage to the antenna, plan all mechanical aspects
of your installation carefully. Avoid handling heavy or unwieldy masts by yourself, and
make sure a second person is available to assist you in an emergency. Never work on a
roof or climb a tower alone!