CIRCUTOR DISPENSER Series - Manual (Page 82)

5�2�2�- LEDs
The unit features 2 LEDs:
LED Pilot
LED
Verification
Figure 92:Indications of the LEDs of the Dispenser Universal
- Verification, with a constant of 1000 imp/kWh. The verification LED has two different func-
tions:
 "No load" status signal”. The LED remains lit when the consumption of energy re-
corded by the Dispenser is insufficient for its start-up.
 Verification of active energy. The verification LED is normally configured to gener-
ate pulses in proportion to the active energy being consumed.
- Pilot: It indicates the different states of the micro-grid, as well as the different alarms, accord-
ing to the type of contract.
A series of priorities are established to display the pilot LED, since different micro-grid or alarm
states can be activated at the same time.
The properties of the different states of the micro-grid and the alarms are shown in Table 31 .
Table 31: Priorities and states of the micro-grid�
Priority Pilot LED Status
1 Steady red Open relay.
2 Fast flashing amber EDA units below the energy pre-warning value.
3 Slow flashing amber Contract validity period less than the pre-warning days.
4 Slow flashing red Micro-grid in the energy restriction status
5 Steady green Significant EDA reserve (overflow)
6 Fast flashing green Excess power in the micro-grid.
7 Slow flashing green Micro-grid in the energy bonus status.
82
Dispenser Universal System
Instruction Manual