CIRCUTOR DISPENSER Series - Manual (Page 80)

5�1�4�2�- THREE-PHASE MODEL�
3 4 6
L1
N
CARGA / LOAD
21 22
1 7 9 10 12
L2
L3
Figure 89: Connection diagram of the three-phase Dispenser Universal�
Note: The diagram also shows the terminals of the auxiliary relay, 21 and 22.
5�1�5�- SEALS
The unit can be protected with the following seals:
 Sealable button, some functions can be enabled for this button, which can only be
executed if the seal is removed, showing proof that the operation was carried out.
 Laboratory seal, the laboratory seal is found inside the unit, under the wire cover
lid. This seal is attached when the metrological verification process is complete.
 Wire cover lid seal, this seal is attached during the installation of the unit. The pur-
pose of this seal is to prevent any form of fraud from the user.
Sealable button
Laboratory seal
Wire cover lid seal
Figure 90:Distribution of seals in the unit�
80
Dispenser Universal System
Instruction Manual