CIRCUTOR computer PLUS-TF Series - Manual (Page 47)

47
8.2 Measurable parameters
 The options available and measurable parameters are summarised on table 8.1.
 Each option can be selected with two different ways:
A) Search the specific parameter and press OK
B) Moving onto the next or previous screen with the browsing arrows.
Options Display Parameters displayed on the screen
Power, cos  , FPIII Fig. 70
Displays the three-phase active, power factor and apparent power and the cos  and
three-phase PF
Status III Fig. 71 Shows the number of steps connected, kvarC III connected and the frequency of supply
Status Fig. 72 Shows the kvarC connected to each phase
cos  Fig. 73 Shows the cos  of each phase and the cos  III
PF Fig. 74 Shows the PF of each phase and PF III
V phase-phase Fig. 75 Shows the phase - phase voltages of the installation
V phase-neutral Fig. 76 Shows the phase - neutral voltages of the installation
I line Fig. 77 Shows the line current of each phase
I neutral Fig. 78 Shows the installation's neutral current (parameter calculated, not measured)
I Cond Fig. 79 Shows the current of each phase of the capacitor bank
I leak, I N Cond Fig. 80
Shows the leakage current (measured) and the neutral current (calculated) of the
capacitor bank.
Power III Fig. 81 Shows the three-phase active, reactive and apparent power
kW Fig. 82 Shows the active power of each phase
kvar Fig. 83 Shows the power factor of each phase
kVA Fig. 84 Shows the apparent power of each phase
Temperature Fig. 85
Shows the temperature inside the Computer. This temperature is usually 10ºC above the
temperature in the cabinet's environment.
Imported Energy III Fig. 86 Shows the energies in kWh, kvarL and kvarCh, imported since the last meter reset.
Exported Energy III Fig. 87 Shows the energies in kWh, kvarL and kvarCh, exported since the last meter reset.
(*) Only in Computer plus TF-CDI
Table 8.1.- Options of the measurement menu and data measured