CIRCUTOR MDC-20 - Manual (Page 40)

MDC-20
Page 40 of 58 User Manual
Each group shows the load disconnection sequence that has been configured and the total
powers of the loads for the group. The load list in the group, the power configured for each load
and the associated disconnection calendar, if applicable, are shown on the right-hand side.
When accessing the load group tab (Fig.8-25) you can add new groups or modify or remove
existing groups. You can also add or remove loads to and from a group.
With the buttons / you can modify the position of the groups and loads in the table, thus
changing the order of priority.
Fig.8-25 . – Configuration of load groups
To add a new load group you must select the button “Add” from the left-hand side of the
menu. When adding a new load group, the user must indicate the name and sequence of the
load group.
Fig.8-26 . – Add groups
Name: Define the required name for that load group.
Sequence: Define the order in which the loads will be connected/disconnected in the group.
• LIFO: The last load that is disconnected will be the first to be connected.
• FIFO: The load that has been disconnected the longest will be the first to be connected,
cyclic queue.