CIRCUTOR MDC-20 - Manual (Page 24)

MDC-20
Page 24 of 58 User Manual
Once the application has been imported, you can access the configuration of the unit's
parameters. To configure the unit and the maximum demand control, see section 7.5. For
events, discriminators and advanced configurations see the EDS tutorial and manual available
at:
http://www.circutor.es/software.aspx
7.4 Exporting the application
Once the unit configuration application has been generated, it must be exported to the MDC-20
so that this can execute it. To export the application, select the button . The application shows
the following window (Fig.7-3)
Fig.7-3 . – Export window of the application
The IP address of the MDC-20 and the port used by the unit (by default port 80) must be
configured in this window.
The default options are shown in ‘Engine preferences’, but can be modified to send the
application to any other communications engine.
If the ‘Verify application’ option is selected, before sending the application to the engine it is
checked that this is correct; if not, invalid elements are reported.
If the ‘Configure communication speeds with the units’ option is selected, it will try to
communicate with the units before sending the application and display a summary of the units it
could not communicate with.
7.5 MDC-20 configuration options
The PowerStudio® software configuration options for the MDC-20 are those shown in Fig.7-4
and detailed below: