Dukane 8768 - Manual (Page 25)

25
2. Installation and Connections
Connecting an External Monitor
AC IN
COMPONENT
Y Cb/Pb Cr/Pr
AUDIO
AUDIO
AUDIO
L/MONO S-VIDEO
PC CARD USB(COMPUTER) USB(MOUSE)
COMPUTER 2 PC CONTROL
R
L/MONO VIDEO R
AUDIO MONITOR OUT AUDIO COMPUTER 1
MONITOR OUT
You can connect a separate, external monitor to your projector to simultaneously view on a monitor the RGB analog
image you're projecting.
To do so:
1. Turn off the power to your projector, monitor and computer.
2. Use a 15-pin cable to connect your monitor to the MONITOR OUT (Mini D-Sub 15 pin) connector on your projector.
3. Connect the supplied power cable. See page 28.
4. Turn on the projector, monitor and the computer.
NOTE:
• The MONITOR OUT connector outputs RGB signal during Idle mode. When the projector goes into standby mode, the image on
an external monitor disappears for a moment.
• When the projector is in the standby mode, the image may not be correctly displayed while the cooling fans are running
immediately after turning on or off the power.
• Daisy chain connection is not possible.
RGB signal cable (supplied)
RGB signal cable (not supplied)