Dukane 8768 - Manual (Page 16)

16
1. Introduction
Terminal Panel Features
COMPONENT
Y Cb/Pb Cr/Pr
AUDIO
AUDIO
AUDIO
AUDIO
L/MONO
S-VIDEO
COMPUTER 1 AUDIO
PC CARD
USB(COMPUTER)
USB(MOUSE)
MONITOR OUT
COMPUTER 2 PC CONTROL
R
L/MONO VIDEO R
7 8 10
6 9
11
6. S-VIDEO Input Connector (Mini DIN 4 Pin)
Here is where you connect the S-Video input from an
external source like a VCR.
NOTE: S-Video provides more vivid color and higher
resolution than the traditional composite video format.
7. USB (MOUSE) Port (Type A)
Connect a commercially available USB mouse. You
can operate the menu or Viewer with the USB mouse
via this port.
8. USB (COMPUTER) Port (Type B)
Connect this port to the USB port (type A) of your PC
using the supplied USB cable. You can operate your
computer's mouse functions from the remote control.
9. PC CONTROL Port (D-Sub 9 Pin)
Use this port to connect your PC to control your pro-
jector via a serial cable. This enables you to use your
PC and serial communication protocol to control the
projector. A commercially available RS232C cross
cable is required to use this port. You can also control
the projector by using Dynamic Image Utility 2.0 in-
cluded on the supplied CD-ROM.
To do so you must first have Dynamic Image Utility
2.0 installed on your PC. If you are writing your own
program, typical PC control codes are on page 119.
10. PC CARD Slot
Insert a PC card here.
11. PC CARD Eject Button
Press to partially eject a PC card partially.