Components and interfaces, Components and interfaces –19 – Altera SDI HSMC User Manual
Page 27
Chapter 2: Board Components
2–19
Components and Interfaces
© July 2009 Altera Corporation
lists the jumper component reference and the manufacturing information.
Components and Interfaces
This section describes the SDI HSMC interface.
The SDI HSMC contains an Altera standard HSMC connector to connect to a host
board. All the other connector interfaces on the SDI HSMC are connected to the
HSMC connector.
show the pin-outs of the HSMC connector
for banks 1, 2, and 3, respectively.
Table 2–11. Jumper Descriptions and Schematic Signal Names
Board
Reference
Schematic
Signal Name
Description
I/O Standard
J4
CD_MUTE2
Carrier detect jumper switch which connects to RX channel 2
(CD_MUTE2) on U8. This jumper is normally installed.
Signal short
J5
EQ_BYPASS2
Equalizer bypass for RX channel 2. The equalizer can be bypassed
manually when EQ_BYPASS2 signal is tri-stated. This jumper is
normally not installed and the switch is controlled by asserting the
EQ_BYPASS2
signal. A high signal bypasses the SDI receiver equalizer.
CMOS
J6
CD_MUTE1
Carrier detect jumper switch which connects to RX channel 1
(CD_MUTE1) on U10. This jumper is normally installed.
Signal short
J7
EQ_BYPASS1
Equalizer bypass for RX channel 1. The equalizer can be bypassed
manually when EQ_BYPASS1 signal is tri-stated. This jumper is
normally not installed and the switch is controlled by asserting the
EQ_BYPASS1
signal. A high signal bypasses the SDI receiver equalizer.
CMOS
Table 2–12. Jumper Component Reference and Manufacturing Information
Board Reference
Device Description
Manufacturer
Manufacturer
Part Number
Manufacturer Website
J4, J6
Jumper Shunt
AMP/Tyco
881545-2