Altera Stratix IV E FPGA - Manual (Page 28)

6–2 Chapter 6: Board Test System
Stratix IV E FPGA Development Kit User Guide June 2011 Altera Corporation
The Board Test System GUI communicates over the JTAG bus to a test design running
in the Stratix IV E device.
Figure 6–1 shows the initial GUI for a board that is in the
factory configuration.
Several designs are provided to test the major board features. Each design provides
data for one or more tabs in the application. The Configure menu identifies the
appropriate design to download to the FPGA for each tab.
After successful FPGA configuration, the appropriate tab appears and allows you to
exercise the related board features. Highlights appear in the board picture around the
corresponding components.
The Power Monitor button starts the Power Monitor application that measures and
reports current power and temperature information for the board. Because the
application communicates over the JTAG bus to the MAX II device, you can measure
the power of any design in the FPGA, including your own designs.
Figure 6–1. Board Test System Graphical User Interface