Altera Stratix IV E FPGA User Manual
Page 21
Chapter 4: Development Board Setup
4–5
Factory Default Switch Settings
June 2011
Altera Corporation
Stratix IV E FPGA Development Kit User Guide
4. Set DIP switch bank (SW4) to match
5. Set the board jumpers to match
, and
Table 4–3. SW4 Dip Switch Settings
Switch
Board
Label
Function
Default
Position
1
USER_DIPSW0
Switch 1 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Open
2
USER_DIPSW1
Switch 2 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Open
3
USER_DIPSW2
Switch 3 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Open
4
USER_DIPSW3
Switch 4 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Open
5
USER_DIPSW4
Switch 5 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Closed
6
USER_DIPSW5
Switch 6 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Closed
7
USER_DIPSW6
Switch 7 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Closed
8
USER_DIPSW7
Switch 8 is a user-defined switch and has the following options:
■
When closed, a logic 0 is selected.
■
When open, a logic 1 is selected.
Closed