Altera Cyclone V GT FPGA - Manual (Page 11)

Chapter 3: Software Installation 3–3
Installing the USB-Blaster II Driver
September 2014 Altera Corporation Cyclone V GT FPGA Development Kit
User Guide
The installation program creates the Cyclone V GT FPGA Development Kit directory
structure shown in
Figure 3–1 .
Table 3–1 lists the file directory names and a description of their contents.
Installing the USB-Blaster II Driver
The Cyclone V GT FPGA development board includes integrated USB-Blaster
circuitry for FPGA programming. However, for the host computer and board to
communicate, you must install the On-Board USB-Blaster II driver on the host
computer.
f For installation instructions for the On-Board USB-Blaster II driver, refer to the Cable
and Adapter Drivers Information page of the Altera website.
Figure 3–1. Cyclone V GT FPGA Development Kit Installed Directory Structure (1)
Note to Figure 3–1 :
(1) Early-release versions might have slightly different directory names.
documents
board_design_files
The default Windows installation directory is C:\altera\ \.
examples
factory_recovery
demos
kits
cycloneVGT_5cgtfd9ef35_fpga
Table 3–1. Installed Directory Contents
Directory Name Description of Contents
board_design_files
Contains schematic, layout, assembly, and bill of material board design files. Use these files as a
starting point for a new prototype board design.
demos Contains demonstration applications.
documents Contains the kit documentation.
examples Contains the sample design files for the Cyclone V GT FPGA Development Kit.
factory_recovery
Contains the original data programmed onto the board before shipment. Use this data to restore
the board with its original factory contents.