Altera ASI MegaCore Function - Manual (Page 14)

Chapter 2: Getting Started 2–5
Compile the Design and Program a Device
January 2014 Altera Corporation Asynchronous Serial Interface (ASI) MegaCore Function User Guide
4. In the New Test Bench Settings dialog box, perform the following steps:
a. In the Test bench name box, type the testbench setup name.
b. In the Top level module in test bench box, type the following as the project
testbench name, tb_asi_mc.
c. In the Design instance in test bench box, type the name of the top-level
instance.
d. Under Simulation period, set End simulation at to 500 µs.
e. Add the testbench files. In the File name field, browse to the location of the
testbench, tb_asi_mc, click Open and then click Add.
f. Select the files and click OK.
5. On the Processing menu, point to Start and click Start Analysis & Elaboration.
6. On the Tools menu, point to Run EDA Simulation Tool and click EDA RTL
Simulation .
Compile the Design and Program a Device
You can use the Quartus II software to compile your design. Refer to Quartus II Help
for instructions on performing compilation.
After you have compiled your design, program your targeted Altera device and
verify your design in hardware.