Altera Nios II Embedded Evaluation Kit Cyclone III Edition - Manual (Page 73)

D–3 Development Board Version 1.0. Altera Corporation
Nios II Embedded Evaluation Kit, Cyclone III Edition July 2010
Why do I get the error “Can't find valid feature line for core
SD_MMC_SPI_CORE (EC11_0002) in current license;
Error: Error (10003): Can't open encrypted VHDL or Verilog HDL
file” when I try to re-generate the Nios II Standard hardware
design?
The Nios II Standard hardware design contains the SD MMC SPI CORE
which is a component that has been provided by a third party vendor, El
Camino. To compile this core in your SOPC Builder system, you will need
to get a license from El Camino. However, if your particular application
has no need to access the SD Card then you do not need to include the SD
Card core in your system. Simply uncheck this core or delete it and
re-generate the system. You should now be able to rebuild the hardware
system without error.
When your hardware and software image is ready you can add your
design to be loadable by the application selector by following the steps
listed in the FAQ:
“How do I add my own design so the Application
Selector can find and run it?”
Where can I get the SD-Card Controller IP License?
If your design requires access to the on-board SD Card then you can
request an evaluation license or purchase the SD-Card Controller IP,
drivers and FAT File system from El Camino.
El Camino GmbH
Landshuter Str. 1
D-84048 Mainburg
Germany
Tel. +49 - 8751 - 8787 - 0
Fax +49 - 8751 - 842876
Web:
www.elcamino.de
E-mail: [email protected]
How do I add pictures so the Picture Viewer Application can find
them?
1. Connect the SD-Card reader provided in the Nios II Embedded
Evaluation Kit to your PC via a USB port.
2. Remove the SD-Card and place in the SD-Card Reader.
3. Add any .JPEG or .BMP file to the “images” folder on the SD Card.