Pilz ST SB DP S, SW paket PROFIBUS-DP - Manual (Page 36)

Standard Function Blocks
6-4 PROFIBUS-DP-Slave Operating Manual
Copying the Slave configuration from the Master configuration
The configuration data for the Slave is located in the data block from
DW 0384 (see Chapter 4, “Setting Parameters”), while the configuration
data for the Master is entered from DW 0830. The length of the
configuration data is entered in DR of DW 0830. This is followed by the
data.
Compare the values on the Master and the Slave and ensure they match.
The following table provides information on the entries.
NOTICE
The addresses of the data block in which the Master writes the
configuration data can be found in the “DP Master” column. The data block
addresses for the Slave configuration data can be found in the “PSS (DP
Slave)” column. The Slave's configuration data must be checked and, if
necessary, adjusted to that of the DP Master.
Configuration
Amount of configuration data
[Bytes]
1st configuration data byte
2nd configuration data byte
3rd configuration data byte
4th configuration data byte
5th configuration data byte
6th configuration data byte
...
Sum total of input data
[Words]
Sum total of output data
[Words]
DP
Master
DR 0830
DL 0830
DR 0831
DL 0831
DR 0832
DL 0832
DR 0833
...
PSS
(DP Slave)
DW 0813
DR 0384
DL 0384
DR 0385
DL 0385
DR 0386
DL 0386
...
DW 0810
DW 0811
Type
KH
KH
KH
KH
KH
KH
KH
...
KF
KF
Value
06
C0
CD
CF
C0
41
40
...
16
17
Input
data
[Words]
14
2
...
16
Output
data
[Words]
16
1
...
17
Example
Contents