Pilz ST SB DP S, SW paket PROFIBUS-DP - Manual (Page 11)

PROFIBUS-DP-Slave Operating Manual 3-1
This software package is designed to connect a programmable control
system PSS to PROFIBUS-DP. It is essential to use a suitable module or
compact safety system.
This software package is intended for use with the following programmable
control systems PSS:
• PSS DP-S module when using a module rack from the PSS 3000 series.
• PSS1 DP-S module when using a module rack from the PSS 3100
series.
• PSS SB 3006 DP-S programmable safety system as a compact device.
The safety systems are passive subscribers (Slaves) on PROFIBUS-DP.
The meet standard EN 50170 Volume 2, PROFIBUS.
Disregard of the information in this manual and use of the software
package outside the specifications described here will be deemed as
improper application.
INFORMATION
This software package is exclusively for use in non-safety-related
applications. It must be used in the standard section of the PSS.
Conditions for operation:
• The module must be installed in accordance with the PROFIBUS DP-
Slave Hardware Manual and the relevant “Installation Manual” for the
programmable safety system.
• You must be familiar with and adhere to standard EN 50170 Volume 2,
PROFIBUS.
Intended Use