Pilz PMCtendo SZ.41/0/1/2/7/K/H/60/00 - Manual (Page 64)

Operating Manual PMCtendo SZ 
1002405-EN-03
64
9 Technical data
9.9.3 Permitted shaft load
The following values specified for the permitted shaft loads (F
2ax
, F
2radN
, M
2k,N
) apply
• for shaft dimensions according to catalogue and
• drive speeds n
2
≤ 100 min -1 .
The values specified for F
2radN
refer to a load applied to the middle of the drive shaft: x
2
= l/2.
For EMERGENCY STOP operation (max. 1000 load changes), the values for F
2ax
,
F
2radN
and M
2k,N
are multiplied by a factor of 2.
Motor F
2ax
F
2radN
M
2k,N
N N Nm
SZ.31 350 1000 39
SZ.32 350 1000 39
SZ.33 350 1000 39
SZ.41 550 1800 62
SZ.42 550 1800 71
SZ.44 550 1800 71
SZ.51 750 2000 79
SZ.52 750 2400 95
SZ.53 750 2400 107
SZ.55 750 2400 107
SZ.71 1300 3500 173
SZ.72 1300 4200 208
SZ.73 1300 4200 208
SZ.75 1300 4200 225
SZ.82 1750 5600 384
SZ.83 1750 5600 384
SZ.85 1750 5600 384