Spectrum Controls 1756sc-IF8u - Manual (Page 21)

Installing And Wiring Your Module
Read this chapter to install and wire your module. This chapter covers:
• avoiding electrostatic damage
• determining power requirements
• installing the module
• wiring signal cables to the module’s terminal block
Electrostatic
Damage
Electrostatic discharge can damage semiconductor devices inside this
module if you touch backplane connector pins. Guard against electrostatic
damage by observing the following precautions:
CAUTION
ELECTROSTATICALLY SENSITIVE COMPONENTS
• Before handling the module, touch a grounded
object to rid yourself of electrostatic charge.
• When handling the module, wear an approved wrist strap
grounding device.
• Handle the module from the front, away from the
backplane connector. Do not touch backplane connector pins.
• Keep the module in its static-shield container when not in
use or during shipment.
Failure to observe these precautions can degrade the
module’s performance or cause permanent damage.
Chapter 2
!