Pitney Bowes DI600 Inserting System - Manual (Page 93)

Troubleshooting • 6
6-5 SV40221 Rev. C
Problem Remedy Page
SHEETS
Poor Sheet Feed
Sheet Feeder
side guides set
incorrectly.
Set guides to Sheet width and back
off 1/4 turn.
3-14
Sheets loaded
incorrectly.
Make sure stack has been fanned
before loading.
3-14
Multiple sheets feed when one is expected
Sheet Feeder
is programmed
to feed a Pre-
Collated Set.
Check Mail Piece Icon Tree to see
if relevant feeder is set to feed pre-
collated sets.
Correct loading or have Supervisor
correct Job Definition as necessary.
1-11
4-4
Address in wrong position in envelope window
Prime Sheet/Set
incorrectly loaded.
Load Prime (address bearing)
Sheet or Set in the correct
orientation as shown by the Mail
Piece Icon Tree.
1-11,
1-12
Address Position
incorrectly set.
Run a Trial Piece. Say No to Trial
Piece OK? and adjust the address
position.
3-6
Poor Folding
A fold is almost
corresponding with
a perforation on
the sheet, causing
a ‘box fold’ or third
fold.
Run a Trial Piece. Say No to Trial
Piece OK? and slightly change the
fold positions.
3-6