Luxul XBR-2300 - Manual (Page 7)

7
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
4 HARDWARE FEATURES AND INSTALLATION
4.1 Front View
XBR-2300 Front View
„
Factory Reset Button: Used to restore factory default settings.
w
To reset to factory defaults, press and hold the reset button until the SYS LED
turns off, approx. 10 seconds. A factory reset may take approximately a minute to
complete. A successful Factory Reset is indicated by all of the Port LEDs fl ashing
once. When the SYS LED Begins to fl ash the unit is ready.
NOTE: To hard reset the router use the power switch. Turn the router
off, wait 10 seconds and turn the unit back on.
CAUTION: Resetting the XBR-2300 to factory defaults will remove all
custom settings..
Status Indicators:
The following table describes the LED functionality:
Indicator Description
Power On The power is on
Off No power, check power connections
System Flashing Indicates the XBR-2300 is functioning correctly.
On Indicates the XBR-2300 is booting.
Off Indicates the system is not functioning correctly.
WAN/LAN On Indicates the WAN/LAN port is connected correctly.
Flashing Indicates data packets are being transferred
100Mbps On Indicates the corresponding port is in 100Mbps working mode.
Off Indicates the corresponding port is in 10Mbps working mode