Xbr-2300, Static ip – Luxul XBR-2300 User Manual
Page 16

16
XBR-2300
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XBR-2300 Vers: 07314
Static IP:
w
IP Address: Enter the Static WAN IP Address. If unknown, contact your ISP.
w
Subnet Mask: Enter the Static WAN Subnet Mask. If unknown, contact your ISP.
w
Default Gateway: Enter the Static Gateway that corresponds with IP and is
provided by your ISP. If unknown, contact your ISP.
w
Preferred DNS Server/ Alternate DNS server: Enter the DNS server IP address
provided by your ISP. If unknown, contact your ISP.
w
Upstream/Downstream Bandwidth (Optional): Enter the static upstream/down-
stream bandwidth for WAN port1. If unsure of Bandwidths, contact your ISP.
w
MTU Setting: MTU (Maximum Transmission Unit) System default is Auto.
NOTE: Typically there is no need to change this. Improper MTU
configuration may lead to poor network performance.
Dynamic IP: If the access mode is Dynamic IP, the XBR-2300 will obtain an IP address
automatically from your ISP.
w
Upstream/Downstream Bandwidth (Optional): Set the static upstream/down-
stream bandwidth for WAN port1. If you are not sure of the Bandwidths, contact
your local ISP.
w
MTU: MTU (Maximum Transmission Unit). System default is Auto.
NOTE: Typically there is no need to change this. Improper MTU
configuration may lead to poor network performance.
PPPoE: If the access mode is PPPoE, the XBR-2300 will obtain an IP address
via DSL virtual dial-up.