Luxul XBR-2300 - Manual (Page 25)

25
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
5.3.9 Ethernet Settings
Ethernet Settings: Here you can set the speed and duplex of the WAN interfaces
(WAN1 and WAN2). The available options are: Auto, 10Mbps half duplex, 10Mbps full
duplex, 100Mbps half duplex and 100Mbps full duplex. 100Mbps full duplex is the most
common for newer devices.
5.3.10 MAC Address
MAC Address: Allows you to manually specify a MAC address for WAN1, WAN2
and/or LAN.
„
LAN MAC Address: Use this if the specified MAC Address is to be used by the XBR-
2300 in the internal network
„
WAN1 MAC Address: Use this if the specified MAC Address is to be used by the XBR-
2300 for all Internet traffic across WAN interface 1
„
WAN2 MAC Address: Use this if the specified MAC Address to be used by the XBR-
2300 for all Internet traffic across WAN interface 2
„
Restore to Default: Resets the MAC Addresses to factory default settings
NOTE: Some ISPs bind the connection to the user’s computer MAC
Address. In this scenario, copy the computer’s MAC Address to the
corresponding WAN interface MAC address field.
NOTE: MAC Address modifications only take effect when router is rebooted.