Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 83)

Nitrous Menus: Nitrous1 (N2O-1) and Nitrous2 (N2O-2) 82
See Appendix B: Nitrous & Fuel Operation for more information.
6.13 Resume Fuel Percentage
This setting determines the percent at which the fuel resumes if the user has to lift off of the throttle once the
system is active. This setting is only valid if the Hold And Wait option is ON. This setting is used with the
Resume Percent Per Pulse setting to build a Resume Ramp. If the Resume Fuel Percent is greater than the
current Fuel percent, the Resume Ramp is ignored.
Valid Range is 10% to 100% in 1% increments. A setting of 100% disables this feature (no ramp).
Access from the Controller:
From the
Main screen , select the stage by pressing either the "N2O-1" button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Resume Fuel %" menu selection is highlighted and then press the
“ENTER” button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to
accept the new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Resume % Per Pulse" setting is found in the "Nitrous Resume Ramp" dialog box under the "Options" Tab.
Click the "UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.
See Appendix B: Nitrous & Fuel Operation for more information.