Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 118)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 117
7.10 PWM Out Menu
This menu is not currently functional, but will be used in future software builds.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the "PWM
Out Menu" selection is highlighted and then press the “ENTER” button. This menu is not currently functional, so
press "OK" to exit.
7.11 Hall Input Menu
The following options are found in the Hall Input Menu, which can be accessed by the "SETUP" button on the
main screen or by clicking Hall Input tab in the Setup menu of the computer software. Currently, this input can
only be used for vehicle speed signal input.
MPH Option
This option enables the input settings used to configure the Hall Input to monitor vehicle speed. The input signal
needs to be a square wave signal or connected to the output of an open drain hall effect sensor. The Pulse Per
Mile setting in the ECM must be configured properly for an accurate reading.
The Hall Input has a programmable Pull-Up resistor for use in applications that require a Pull-Up resistor, but do
not already have one in the circuit.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Hall Input
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "MPH" option,
then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no change will be
made.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Mile Per Hour" option is found in the "Hall Input
Config" dialog box under the "Hall Input" tab. Click "Mile Per Hour" to enable the MPH option or "OFF" to