Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 78)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 77
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Nitrous On RPM" setting is found in the "Nitrous Control RPM" dialog box under the "Options" Tab. Click the
"UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.
See Appendix B: Nitrous & Fuel Operation for more information.
6.6 Nitrous Maximum RPM / Nitrous Off RPM
This setting controls the maximum RPM level that the nitrous is active. Use this setting to disable the nitrous
when on the rev limiter.
The valid range is 2,000 to 16,000 RPM in 100 RPM increments.
Access from the Controller:
From the
Main screen , select the stage by pressing either the “N2O-1” button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Max RPM" setting is highlighted and then press the “ENTER”
button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the
new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Nitrous Off RPM" setting is found in the "Nitrous Control RPM" dialog box under the "Options" Tab. Click the
"UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.