Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 29)

Installation of the NCC-002 Nitrous Control Center 28
3.1.8 NCC-002 Connected to the LNC-2000 for Simple On/Off Control
Use this configuration to allow the NCC-002 to activate or deactivate the LNC-2000 Launch Control Module
via +12V relay output. In this configuration, the NCC-002 would act as an activation switch for the LNC-2000,
providing the +12V activation for the LNC-2000. The settings on the LNC-2000 would create the timing retard
ramp. See the
LNC-2000 instructions for more information regarding the wiring and settings of the LNC-2000.
To connect the NCC-002 to the LNC-2000 in this configuration:
•
On one end of the orange wire labeled "RELAY2 12V", crimp a terminal and connect the wire to the Relay2
Out terminal on the NCC-002.
•
Connect the other end of the orange wire labeled "RELAY2 12V" to the orange +12V Retard Activation wire
from the LNC-2000.
•
Select the enabling criteria for the Relay2 Output on the NCC-002.
•
Optional: To log timing retard, connect the solid gray wire (Analog Out) from the LNC-2000 to the Analog1
Input terminal on the NCC-002.