Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 114)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 113
Fuel1 Percentage Control Option
If this option is enabled, the selected Relay output is controlled by Fuel1 duty cycle and any other control options
that are enabled.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the desired
Relay Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Fuel1%
Control" option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no
change will be made.
Access from the Computer Program:
From the
Status screen , select the relay by pressing either the "Relay1" button or the "Relay2" button. The
"Fuel1 Percent Enable" option is located in the "Relay Control Options" dialog box. Check the box to enable the
Fuel1 Percentage Control Option or un-check the box to disable the option.
Nitrous2 Percentage Control Option
If this option is enabled, the selected Relay output is controlled by Nitrous2 duty cycle and any other control
options that are enabled.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the desired
Relay Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the
"Nitrous2% Control" option, then the “YES” or “NO” button to change the current selection. If the “NO” button is
pressed no change will be made.
Access from the Computer Program:
From the
Status screen , select the relay by pressing either the "Relay1" button or the "Relay2" button. The