Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 132)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 131
Nitrous Pressure Minimum Value
This setting should be the nitrous pressure that corresponds to the Nitrous sensor minimum voltage.
The Valid Range is 0 to 2000 psi in 1 psi increments.
Access from the Controller:
From the Main screen, press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Fuel Psi
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "N2O Psi Min"
selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons adjust
the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Sensor Min PSI" option is found in the "Nitrous Sensor
Setup" dialog box under the "Nitrous Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Nitrous Pressure Maximum Value
This setting should be the nitrous pressure that corresponds to the Nitrous sensor maximum voltage.
The Valid Range is 0 to 2000 psi in 1 psi increments.
Access from the Controller:
From the Main screen, press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Fuel Psi
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "N2O Psi