Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 108)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 107
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "AFR
Min Voltage" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "AFR Minimum Voltage" setting is found in the "AFR
Input Setup" dialog box under the "Air Fuel Ratio" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
AFR Maximum Voltage
This setting should be set to the voltage that the Wideband controller outputs at the maximum/lean AFR range.
The Valid Range is 0.0 to 5.0 volts in .1 volt increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the AFR
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "AFR
Max Voltage" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "AFR Maximum Voltage" setting is found in the "AFR
Input Setup" dialog box under the "Air Fuel Ratio" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.