Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 77)

Nitrous Menus: Nitrous1 (N2O-1) and Nitrous2 (N2O-2) 76
clicking on the graph will display a menu from which the graph can be manipulated as well, as shown below the
graph.
Right-clicking on the graph will display a menu from which the graph can be manipulated as well, as shown
below.
IMPORTANT—When Saving a new Fuel setup, the software will compare the Nitrous Percentage settings to the
current Fuel Percentage settings. If the Fuel Percentage for a given pulse is less than the
Nitrous Percentage
minus the Fuel Trim percentage (See Setup Menu) the Fuel Percentage will automatically be adjusted to Nitrous
Percentage Fuel Trim. To allow full control of the Fuel Percentage versus Nitrous Percentage set the Fuel Trim
Option to 100%. Do this with caution as a Lean condition can and will result if improper settings are entered!
See Appendix B: Nitrous & Fuel Operation for more information.
6.5 Nitrous Minimum RPM / Nitrous On RPM
This setting controls the minimum RPM level that the nitrous can be active (the nitrous-enabling RPM).
The valid range is 1,000 to 15,000 RPM in 100 RPM increments.
Access from the Controller:
From the
Main screen , select the stage by pressing either the "N2O-1" button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Min RPM" setting is highlighted and then press the “ENTER”
button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the
new setting or press the “ESC” button to exit with no change.