Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 129)

Setup Menu 128
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Fuel PSI Disable Delay" setting is found in the "Fuel PSI
Disable Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in
any numeric value in the valid ranges shown above.
Fuel PSI Nitrous Disable Percentage
This setting allows the user to tell the the controller to only disable the nitrous using the fuel pressure disable
option if the nitrous is ramped up above the set percentage.
For example- If the Fuel PSI disable percentage setting is set to 60%, the nitrous cannot be disabled by the Fuel
PSI option until the nitrous is ramped above 60%, even if the fuel pressure is below the Fuel PSI nitrous disable
setting.
The Valid Range is 0% to 100% in 1% increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel Disable
%" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Fuel PSI Disable Percent" setting is found in the "Fuel
PSI Disable Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type
in any numeric value in the valid ranges shown above.