Hanna Instruments PCA 310 - Manual (Page 31)

31
For list type parameter
In this case the cursor will blink and first letter alternates with a
black square. To modify the value press “UP” or “DOWN”
arrow key until the correct value appears.
Press “CFM” to save the value or press “ESC” to end the
editing without saving the value.
For single numeric values
In this case the cursor will blink by alternating the first digit
and a black square.
Press “RIGHT” or “LEFT” arrow key to focus on the digit that
has to be edited.
To edit the current digit press “UP” or “DOWN” arrow keys.
Press “CFM” to save the value or press “ESC” to end the
editing without saving the value.
For many numeric values on a row
In this case the cursor will go to the first digit of the first parameter.
The cursor will blink but no black square will be displayed.
Select the parameter to be edited by pressing “RIGHT” or “LEFT”
arrows.
To edit the parameter press “SET” key again and the black
square alternating with the first character appears, signaling
that the parameter could be edited.
Depend on the parameter type, the edit procedure is as de-
scribed for list type or single numeric value.
Press “CFM” to save the value or press “ESC” to end the
editing without saving the value. The cursor will prompt the
edited parameter.
Set Time: 10:31
Set Date:2004/01/01
Setpoint :2.50 mg/L
Delta
:0.1 mg/L
Low Point:0.02 mg/L
Low Point:Inactive