Hanna Instruments HI 4211 - Manual (Page 58)

5 8
• If accessing Log History option while logging, last logged data can be visualized on the LCD (see Display
Mode section for details, page 11).
• To stop the logging session, press or /
. The Log Save screen will be displayed in which the
logged lot parameters can be set:
• Press to adjust the log interval and/or the log
sampling or press to save the current log in
the displayed format.
• Press to enter log interval edit menu and use
or to adjust the logging start/stop
time or the log sampling. Press to save the
current value and use or to adjust
next/previous parameter.
Note: The minimum log sampling which can be set is calcu-
lated related to the logging time thus the 5000 records/lot
not to be exceeded (e.g. for a 50.000 seconds logging
time, the minimum log sampling will be 10 seconds).
• Press to exit log interval edit menu and then
press to save the current log with the new
configuration. While the instrument is saving the data,
a “Please wait...” pop-up message will be displayed
on the LCD.
Note: For larger logged lots, the saving time can be up to
several minutes.
LOGGING MODE 2
This logging mode can be used for multiple samples measurement. By choosing this logging mode, and
will be available in Measure mode.
Note: For HI 4212, the or and or will be available in multichannel Measure
mode, depending on the focused channel.
To log data using this mode:
• Press
while in Measure mode to start the logging session. When the measured value is frozen on
the LCD by pressing and the stability criterion is reached, the logged value is the one that has been
frozen on the LCD until returning to normal logging mode by pressing .