EZ-ACCESS PASSPOR - Manual (Page 5)

Page | 5
Observe and avoid all pinch points.
Whenever not actively using the VPL, turn keyed power switch to “OFF” position and remove key.
Always unplug VPL from electrical outlet before cleaning. Only plug VPL back in when area around VPL is dry.
Never operate VPL with damaged electrical wires, cords, or plugs.
The AC electrical plug on this VPL is grounded and intended to be used only with a properly grounded AC outlet. Do
not remove ground pin from AC power cord. If ground pin is broken or missing, immediately contact your dealer to
schedule repairs.
Stop using VPL and immediately and contact your dealer for inspection and service if any defect is suspected.
Do not tamper with or attempt to modify the VPL or any of its systems.
Use VPL only with a qualified helper, if required.
Do not use the VPL to support, attach, or hang planters, baskets, lights, adornments, decorations, clothing, fabrics
or other ornamentals or furnishings.
Components inside the tower must be serviced by a qualified technician. Contact you dealer to schedule
inspections, repairs or service.
Periodic inspections by a qualified technician are recommended to help prevent unsafe conditions.
The VPL’s electrical cord must be routed and situated in a manner that poses no hazards. Do not lay power cords
on or across electrically conductive materials, such as metals and always route power cords in such a manner so no
one can trip over them and that they are not exposed to risk of accidental or incidental damage.
Before and during VPL operation, ensure all hair, jewelry, shirts, ties, shoe laces and all other forms of clothing and
other personal ornamentation are-not and do-not hang up on anything that may create a hazard.
Correct installation, proper use, and following of instructions and obeying safety warnings and of the VPL are
necessary for safe operation.
If service outside the guidelines of this manual is required, please contact your dealer for additional information,
for replacement labels and manuals or to schedule any needed inspections, repairs or service.
VPL must be anchored to a concrete slab before operating the VPL while it is occupied. Using the VPL while
occupied before installation can be hazardous.
Maintaining all labels and manuals in legible condition is required by the VPL owner and is essential for safe
VPL operation. The VPL comes with various product safety labels. Do not remove safety labels or devices. If
any labels are missing, damaged or become illegible they must be replaced. An illegible decal will fail to alert
individuals on or around the machine of a procedure or hazardous operating conditions. Contact your dealer for
additional information, replacement labels and manuals or to schedule inspections, repairs or service.
Illumination: VPL requires a minimum illumination at the landing edge of the floor with the landing door open of
not less than 50 Ix (5 fc).
Illumination of at least 100 lx shall be provided:
(a) at the drive unit in the location where periodic maintenance and inspection are required;
(b) on the carriage at the seat or platform surface and at the operating devices; and
(c) at the floor level of landing/loading points.
For proper warranty coverage, fill out and return the included warranty form.
Keep all panels and protective coverings in place.
The VPL warranty is not transferable.
Attempting to tamper with or modify any portion of the VPL will void your warranty.
Except as described elsewhere in this manual, maintenance must only be performed by qualified technicians.
Contact your dealer to schedule any needed maintenance, inspections, repairs or service.
Caustics, high alkaline detergents and solutions should not be used to clean aluminum.
Using this VPL for anything other than its intended purpose will void the warranty.