EZ-ACCESS PASSPOR - Manual (Page 13)

Page | 13
12. The control box is secured to inside of tower with zip ties. Locate and cut the zip ties to free the
control box (FIG. 4.9).
a. Remove fasteners securing mounting channels to control box.
b. Position control box into the mounting frame as shown and reinstall the mounting channels
using the fasteners removed in the previous step.
c. Check to make sure that the control box is free to slide entire length of mounting frame.
13. When assembling a 90° Turn Platform, one pivot plate is installed on the side closest to the lift tower
and a welded pivot plate assembly is installed in the opposite corner. After completing Steps 1
through 6 of this section, proceed with the following steps.
14. Determine the end of the platform where the Guard Ramp will be installed then locate the welded
pivot plate assembly (found in the hardware bag) and insert it in the corner pocket furthest from the lift
tower on that side until fully engaged and tighten the set screws in the corner pocket securely
(FIG. 4.10).
FIG. 4.10
FIG. 4.11