EZ-ACCESS PASSPOR User Manual
Page 35
Page | 35
2. Install a round threaded insert into one end of each 1-
1/2” diameter x 1-1/4” long tube. Use a rubber
mallet to make sure the threaded inserts seat fully into the tubes.
3. Hold one 1-
1/2” diameter x 1-1/4” long tube with the threaded insert to the inside of the guard wall (the
tube will be oriented toward the guard wall post or top rail and the insert will be oriented toward the
other side of the platform
). Install a 5/16”-18 x 3” long hex cap screw through the hole you previously
drilled and into the threaded insert and tighten securely. Refer to
Repeat for the other guard wall post or top rail.
FIG. 9.4
4. Locate the closure elbows and disassemble them by removing the elbow assembly screws and nuts.
Install the elbow halves without the threaded holes into both ends of the 1-
1/2” diameter x 46” long
Platform Safety Rail tube. Make sure rounded side of the elbow halves are facing the same direction in
both ends then tighten internal set screws with a T-Handle Allen wrench or similar tool.
FIG. 9.5
T-Handle Allen wrench or
similar tool