EZ-ACCESS PASSPOR - Manual (Page 34)

Page | 34
INSTALLATION:
For a Straight Platform, measure
3/4” in from the end of one guard wall post and make a mark. Now measure
2-1/2 ” down from the top of the guard wall post (excluding the plug) and mark. Find the location where the two
marks cross. Mark a location on the other guard wall post 2-1
/2” down from the top of the guard wall post
(excluding the plug) and 48- 5/8” away from where the two marks cross on the opposite post. Drill 3/8” diameter
holes through both posts at the marked locations ( FIG. 9.3A ).
FIG. 9.3A
For a 90°Turn Platform, measure 5-3/16
” in from the end of one rear guard wall post and make a mark on the
rear guard top rail
. Now measure 1” down from the top of the rear guard wall top rail and mark. Find the
location where the two marks cross. Mark a location on the other end of the rear guard wall top rail 1” down
from the top and 48- 5/8” away from where the two marks cross on the opposite side. Drill 3/8” diameter holes
through the rear guard wall top rail at the marked locations ( FIG. 9.3B ).
FIG. 9.3B
DRAWING IN THIS SECTION TO REFLECT
LOWERINGMOUNTING LOCATION, AND
REWRITE INSTRUCTIONS
DRAWING IN THIS SECTION TO REFLECT
LOWERINGMOUNTING LOCATION, AND
REWRITE INSTRUCTIONS