EZ-ACCESS PASSPOR - Manual (Page 36)

Page | 36
5. Install the elbow halves with the threaded holes onto the portion of the 5/16”-18 x 3” long hex cap screw
which extends past the threaded inserts (shown in FIG. 9.4 ) and tighten securely. After tightening, the
rounded side of the elbow halves should be on the bottom facing the platform. It may be necessary to
loosen the hex cap screws holding the round tubes with the threaded inserts and rotate in one direction
or the other then re-tighten to get the elbows to end up in the correct orientation when fully secured
(
FIG. 9.6 ).
6. Assemble the 1- 1/2” diameter x 46” long Platform Safety Rail tube to the guard wall by reassembling
the elbows. Align the holes in the elbow halves and replace the center insert then insert the elbow
assembly screw through all the components on one side. Repeat on the opposite side. Place the elbow
assembly nuts on the screws and tighten securely (
FIG. 9.7 ).
7. Check to ensure the Platform Safety Rail is properly attached and secured. If needed, tighten internal
set screws, elbow assembly screws and 5
/16”-18 x 3” long hex cap screws.
FIG. 9.6
FIG. 9.7
“GRAB BAR”