EXFO FTB-635 Wideband Copper and DSL Test Module - Manual (Page 170)

Multimeter Tests
162 FTB-635
Balance Test
The current group and the current test which is being measured is
displayed in the status bar, for example Signal\Balance.
The page displays the following parameters:

Edit Thresholds button opens a new page that allows you to set the VF
Balance threshold.

Test Status displays the current state of measurement or an error
message.

Save Test button opens a new page that allows you to save a snapshot
of test results into a result file. Refer to Save Test on page 74 for more
information.
Setting Threshold Values
The Test Thresholds page allows you to set the Balance Threshold values
for the test.
To set the Threshold values:
1. From the Copper main menu Test Groups, select Signal test
.
2. From the Tests menu, select Signal test.
3. Tap Active tab for which you want to set the Threshold values.
4. Tap Edit Thresholds button to open the Test Thresholds page.
5. Set the Threshold values as required.
6. Tap Close to confirm and exit the page.