EXFO FTB-635 Wideband Copper and DSL Test Module - Manual (Page 111)

Auto Test
Copper and xDSL Tests 103
POTS Auto Test
Setting Test Parameters
The Test Parameters page allows you to set the POTS Auto test
parameters.
To set the Parameter values:
1. From the Copper main menu Test Groups, select Auto Test
.
2. From the Tests menu, select POTS Auto Test.
3. Tap Edit Parameters button to open the Test Parameters page.
4. Set the parameters as required.
5. Tap Close to confirm and exit the page.
The page allows you to set the following parameters:

Phone Book Group allows you to select the Group # from a list of
phone book groups that include mW tone entries.

Milliwatt Tone Entry displays at least 1 mW tone entry number from
the selected Phone Book Group.

Quiet Line Entry displays the quiet line entry number from the
selected Phone Book Group.

VF Noise Filter displays the voice frequency noise filter used,
dependent on ITU or ANSI Standard mode and Noise Filter set in
Setup/Application Settings.