Eurocom TN12R Tablet - Manual (Page 46)

40 - Troubleshooting
Concise User’s Guide
English
Troubleshooting
Problem Possible Cause - Solution
The Wireless LAN/
Bluetooth/3.5G modules
cannot be detected.
The modules are off. Check the LED indicator / to see if the WLAN/Bluetooth/3.5G
module is on or off. If the LED indicator is off, then press the Fn + F11 (WLAN), Fn + F12
(Bluetooth) or Fn +
(3.5G) in order to enable the modules (see Table 2, on page 14 and
Table 3, on page 16 ).
The Bluetooth module is
off after resuming from
Sleep. The Bluetooth module’s default state will be off after resuming from the Sleep power-saving
state. Use the key combination (Fn + F12) to power on the Bluetooth module after the computer
resumes from Sleep.
A file cannot be copied to/
from a connected
Bluetooth device. Transferring data between the computer and a Bluetooth enabled device is supported in one
direction only (simultaneous data transfer is not supported). If you are copying a file from
your computer to a Bluetooth enabled device, you will not be able to copy a file from the
Bluetooth enabled device to your computer until the file transfer process from the computer has
been completed
The captured video files
from the PC Camera are
taking up too much disk
space. Note that capturing high resolution video files requires a substantial amount of disk space for
each file.
Note that the Windows Vista system requires a minimum of 15GB of free space on the C: drive
system partition. It is recommended that you save the capture video file to a location other than
the C:drive, limit the file size of the captured video or reduce video resolution (Options > Video
Capture Pin... > Output Size).