Eurocom M4 User Manual
Page 130
Upgrading The Computer
6 - 14 Upgrading the System Memory (RAM)
6
4.
The RAM module will
pop-up, and you can remove it.
5.
Pull the latches to release the second module if necessary.
6.
Insert a new module holding it at about a 30° angle and fit the connectors firmly
into the memory socket.
7.
The module’s pin alignment will allow it to only fit one way. Make sure the module
is seated as far into the socket as it will go. DO NOT FORCE the module; it should
fit without much pressure.
8.
Press the module in and down towards the mainboard until the socket levers click
into place to secure the module.
9.
Replace the component bay cover (see page
).
Figure 6 - 10
RAM Module
Removal
Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module’s
performance.
4
4
Single Memory Module
Installation
If your computer has a single memory
module, then insert the module into the
Channel 0 (JDIMM1) socket. In this
case this is the lower memory socket
(the socket closest to the mainboard).