Eurocom M4 - Manual (Page 124)

Upgrading The Computer
6 - 8 Removing the Component Bay Cover
6
Replacing the Component Bay Cover
1. Reinsert the component bay cover by placing it on the bottom case assembly and
aligning the three pins
- with the slots in the case.
2. Angle the cover up to make sure that the cover pins fit in the slots, and then place
the cover down onto the computer and ensure that the fit is tight before replacing
the screws
- ( Figure 6 - 3 on page 6 - 6 ).
Figure 6 - 5
Component Bay
Cover Replacement
1 3
1 3
1
2
3