Ditch Witch RT115 - Manual (Page 124)

RT115 Tier 3- SAW ATTACHMENT
OPERATION
124 RT115 Tier 3 - SAW ATTACHMENT
OPERATION
Cruise Control Operation
1. Ensure ground drive control is in neutral.
2. Ensure hydraulic motor switch is in low.
3. Ensure gearbox control is in 1 (low).
4. Ensure cruise control selector is in MANUAL.
5. Ensure that all controls are set as desired.
6. Move cruise control RPM control to arrow at center.
7. Move cruise control selector to AUTO.
8. Following procedures in "Operation," begin sawing to desired
depth.
9. When desired depth is reached, ensure throttle is fully open.
10. Slowly move ground drive control to full forward position.
11. Slowly adjust cruise control rpm control to match digging
conditions. In harder digging conditions, higher cruise control
rpm setting may improve digging performance. In easier
digging conditions, lower cruise control rpm setting may
increase ground drive speed. See "Operating Tips."
12. When finished digging, move ground drive control to neutral.
13. Move cruise control selector to MANUAL.
14. Allow saw to dig itself free before stopping attachment.
EMERGENCY SHUTDOWN - Turn ignition switch to STOP.
Cruise Control Operation
1. Ensure ground drive control is in neutral.
2. Ensure hydraulic motor switch is in low.
3. Ensure gearbox control is in 1 (low).
4. Ensure cruise control selector is in MANUAL.
5. Ensure that all controls are set as desired.
6. Move cruise control RPM control to arrow at center.
7. Move cruise control selector to AUTO.
8. Following procedures in "Operation," begin sawing to desired
depth.
9. When desired depth is reached, ensure throttle is fully open.
10. Slowly move ground drive control to full forward position.
11. Slowly adjust cruise control rpm control to match digging
conditions. In harder digging conditions, higher cruise control
rpm setting may improve digging performance. In easier
digging conditions, lower cruise control rpm setting may
increase ground drive speed. See "Operating Tips."
12. When finished digging, move ground drive control to neutral.
13. Move cruise control selector to MANUAL.
14. Allow saw to dig itself free before stopping attachment.
EMERGENCY SHUTDOWN - Turn ignition switch to STOP.